Danfoss TripleLynx CN Instalační manuál stáhnout pdf (Strana 226)

Solar-Log1000: Configuration at the unit

Configuring the inverter data (Basic/Inverter)

226 of 268 Solar-Log

1000/500/200

Installation

Procedure

1 Enable required mode Inverter mode, Overallyield meter or Consump-

tion meter.

2 Touch the input box at Connect. module power

 The virtual keyboard is opened.

3 Enter the desired module power and confirm with OK

4 Touch the input box beside Module field

 The virtual keyboard is opened.

5 Enter the number of the module field and confirm with OK

6 Touch Save, then Next to go to the next dialogue.

Setting the module and power data

Dialogue for standard inverters

In standard inverters, the individual strings are interconnected internally.

Dialogue boxes

 Connect. module power

A value for the connected module power at the inverter is needed in order

to make power comparisons between the different inverters and offset

them against each other.

 Module field (1-9)

In the module field, the same types of strings are placed together for sys-

tem monitoring and to be monitored together. For a roof with equal mod-

ules, which have the same alignment and the same angle of inclination on

the roof, all strings are assigned to module field “1”. If there are other in-

verters connected, which are operating with a different roof alignment,

these strings are given the module field number “2”. etc.

Procedure

In order to set the module and power data:

1 Touch the input box at Connect. module power

 The virtual keyboard is opened.

2 Enter the desired module power and confirm with OK

3 Touch the input box beside Module field

 The virtual keyboard is opened.

4 Enter the number of the module field and confirm with OK

5 Touch Save, then Next to go to the next dialogue.

1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 267 268

Žádné komentáře

Danfoss TripleLynx CN Instalační manuál Strana 226