Danfoss TripleLynx CN Instalační manuál stáhnout pdf (Strana 151)

Configuration at a PC

Configuring network settings (Basic/Lan)

Solar-Log

1000/500/200

Installation 151 of 268

This is divided into the following sections:

 Network settings

 Internet access

 Network router

This is only available if the “Network Router” option is enabled in the

“Internet Access” section.

 analogue modem (Solar-Log

1000

analogue modem package)

 GPRS modem (Solar-Log

1000

GPRS / mobile communication package)

“Network Settings” section

If no internet connection is available, the following functions are not enabled:

E-mail, SMS messages, data input to the homepage. In this case, only local

access is possible, either through the PC or router.

1 Under IP Address enter the fixed IP number if obtain automaticallyis disa-

bled in IP address.

The default address is 192.168.178.49 and must be adapted through a di-

rect PC connection, or through a router without the DHCP service, in order

to allow access from the PC.

2 The Subnet mask is 055.255.255.0 by default and must be the same over

the whole network.

“Internet Access” section

If Network Router is selected, the Solar-Log™ routes all internet-specific data

through the network interface to the gateway address. The router installed

there is responsible for ensuring that the data are routed correctly.

“Network Router (DSL, cable, ISDN)” section

If enabled in the Internet Access section, the Network Router section is dis-

played. The following inputs are required\:

3 Under IP Address set obtain automatically.

This is only possible if the Solar-Log™ is connected to an internet router

that allows the DHCP function. When the search is started, the Solar-Log™

attempts to obtain an IP address through an internet router. This can take

up to 60 seconds.

If the DHCP server is disabled in the router, network configuration must be

carried out manually. In this case, please consult a network specialist who

can assign a suitable network address, make the other gateway settings,

and so on.

4 The IP address of the Gateway is obtained dynamically by DHCP.

5 Click on Save

 When the settings are saved, the Solar-Log™ is restarted. After re-

starting, the new IP address is shown accordingly, and the network

settings are active.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 267 268

Komentáře k této Příručce

Žádné komentáře

Danfoss TripleLynx CN Instalační manuál Strana 151

Komentáře k této Příručce

Související produkty a manuály pro Napájecí adaptéry a střídače Danfoss TripleLynx CN