Danfoss VLT 5000 FLUX Provozní pokyny stáhnout pdf (Strana 61)

VLT

5000 FLUX

■ Operation and Display

■ Introduction

The parameter group 001 - 099 provides the adjustment and settings for the operation site and for the

operation and settings of the LCP (Local Control Panel) display and storing unit.

PNU Parameter Factory setting Range Changes 4-Setup Conversion Data

# description during operation index type

001 L

Language

English No No 0 5

002 L

Local/remote control

Remote control Yes Yes 0 5

003 L

Local reference

000.000 Yes Yes -3 4

004 A

Active setup

Setup 1 Yes No 0 5

005 P

Programming setup

Active setup Yes No 0 5

006 C

Copying of setups

No copying No No 0 5

007 L

LCP copy

No copying No No 0 5

008 D

Display scaling speed

1 0.01 - 100.00 Yes Yes -2 6

009 D

Display lini 2

Speed [rpm] Yes Yes 0 5

010 D

Display line 1.1

Reference [%] Yes Yes 0 5

011 D

Display line 1.2

Motor current [A] Yes Yes 0 5

012 D

Display line 1.3

Power [kW] Yes Yes 0 5

013 L

Local operation mode

LCP control Yes Yes 0 5

014 L

Local stop

Enable Yes Yes 0 5

015 L

Local jog

Not possible Yes Yes 0 5

016 L

Local reversing

Not possible Yes Yes 0 5

017 L

Local reset of trip

Possible Yes Yes 0 5

018 L

Lock for data change

Not locked Yes Yes 0 5

019 O

Operating state at power-up, local

control

Forced stop, use

saved ref.

Yes Yes 0 5

024 U

Userdefined Quick Menu

Not active Yes No 0 5

025 Q

Quick Menu Setup

000 0-999 Yes No 0 6

Changes during operation:

"Yes" means that the parameter can be changed,

while the frequency converter is in ope

ration. "No"

means that the frequency converter must be stopped

before a change can be made.

-Setup:

"Yes" means that the parameter can

be programmed

individually in each of the four setups, i.e. the

same parameter can have four different data

values. "No" means that the dat

avaluewillbe

the same in all four setups.

onversion index:

This number refers to a conversion figure to

be used when writing or read

ing by means

of a frequency converter.

Conversion index Conversion factor

74 0.1

2100

110

-1 0.1

-2 0.01

-3 0.001

-4 0.0001

Data type:

Data type shows the type and length of the telegram.

Data type Description

3Integer16

4Integer32

5Unsigned8

6Unsigned16

7Unsigned32

9Textstring

✭ = factory setting. () = display text [] = value for use in communication via serial communication port

MG.55.A7.02 - VLT is a registered Danfoss trademark

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 162 163

Komentáře k této Příručce

Žádné komentáře

Danfoss VLT 5000 FLUX Provozní pokyny Strana 61

Komentáře k této Příručce