Danfoss VLT 6000 Manuál s instrukcemi stáhnout pdf (Strana 11)

Cascade Controller Option

■ 1. Access to Control Card Cassette

• Remove Local Control Panel (LCP) keypad by

pulling out from top by hand. LCP connector

on panel back will disconnect.

• Remove terminal protective cover by gently

prying with screw driver at top notch and lift

cover out of guide pin fittings.

• Open access cover to internal AFD components.

(Drive configurations vary.)

■ 2. Disconnect AFD Drive Control Wiring

• Remove control wiring by unplugging

connector terminals.

• Remove wiring clamp by removing two

screws. Save for reassembly.

• Loosen two captive screws securing control

board cassette to AFD chassis.

MG.60.I5.22 - VLT is a registered Danfoss trademark

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 67 68

Žádné komentáře

Danfoss VLT 6000 Manuál s instrukcemi Strana 11