Danfoss TS715 Si Uživatelský manuál

TS715Installation & User Instructionssingle channel timeswitch

10User InstructionsYour timeswitchThe TS715 allows you to switch your system on and off at times that suit you. You can programme up to 3 ON/OFF times

11Setting the correct Time and DayBefore you start This will reinstate the preset programmes and sets the time to 12.00pm on Monday (MO) Press and ho

12SETTING THE DAY Press DAY repeatedly until the correct day of the week is displayed. MO is Monday, TU is Tuesday etc. Accepting the preset programme

13!Before you change the preset programmesYour installer will have set your unit to operate in one of the following modes:● 5/2 day - one set of prog

14Programming the heating & hot water in 5/2 day mode1. Press PROG until SET ON TIME appears at the top of the display and MOTUWETHFR appears a

154. Press the DAY button once and SASU will appear at the bottom of the display. Either press COPY to keep the same settings for Saturday and Sunday

161. Press PROG until SET ON TIME appears at the top of the display and MO appears at the bottom of the display. Use the + and - buttons to set the t

17 Continue programming the rest of the week by pressing: a) NEXT ON/OFF button to move to the next setting, b) + and - buttons to amend the time

18Programming heating & hot water system - 24 hour mode1. Press PROG until SET ON TIME appears at the top of the display. Use the + and - buttons

19Running your Programme To run the programme: press the SELECT button. As you press the SELECT button the display will change between ON, OFF,

2INDEXIndexInstallation Product specifi cation 3 Installation 4 Wiring 5 DIL switch settings 5 Wiring Conversion 6-9 User Your timeswitch 10

20+1HR = pressing this button when the unit is in AUTO or ALLDAY mode will cause the system to remain on for an extra hour. If it is pressed while t

21Open the fl ap on the front of the unit to reveal the programming buttons.To change from Summer to Winter (clocks back) -  press and hold - button

22Fault Check List Troubleshooting

23

Danfoss Randall LtdAmpthill RoadBedfordMK42 9ERTel: 01234 364621Fax: 01234 219705Still having problems?Call your local heating engineer:Name:Tel:Visit

3Please Note: This product should only be installed by a qualifi ed electrician or competent heating installer, and should be in accordance with the cu

4Installation Remove wallplate from unit by unscrewing the two screws on the bottom edge of the unit. From the top left hand corner of the wallpla

5WiringCOMOFFONMains fused 3ATS715 (3066 12/01)Wiring & DIL switch settingsAlways switch off mains fi rst and never fi t programmer to a live wallpl

6DANFOSS RANDALLTS715MAINSNLNLThe existing wallplate may be used when replacing the following, but the wiring muwire link between L & COM terminal

7LOADAn additional terminal block may be required where these disconnected leadss (or pairs of leads) should be terminatedCOM OFF SPARE ON12 3 4 AB CD

8DANFOSS RANDALLTS715MAINSNLNLThe TS75/TS15 wallplate must be used to replace the existing wallplate when replamains voltage systems, fi t wire link be

9LOADAn additional terminal block may be required where these disconnected leadss (or pairs of leads) should be terminatedCOM OFF SPARE ON12 3 4 ABCDa