Danfoss TP7000 Uživatelský manuál

TP7000 + RFGBFDESDKNLLTPLIInstallation Instructions User Instructions Instructions d’installation Instructions d’utilisateur InstallationsanweisungenI

10c) When all 6 events are correct, press DAY to programme events for Day 2. (If you wish to repeat the previous day’s programme, simply press COPY)

11GB - User InstructionsTo convert to Thermostat mode Press & hold  and  together until display changes to colon blinking & default tempera

12User Overrides To temporarily increase or decrease the programmed temperature – press  or  to select the desired temperature. Extend Event

Part No: 37045 Issue 1 04/05www.danfoss.com/BusinessAreas/Heating

2INDEXInstallation Instructions 3-6User Instructions 7-12Instructions d’installation 13-16Instructions d’utilisateur 17-22Installationsanweisungen

3Installation InstructionsGBImportant note RF products: Ensure that there are no large metal objects, such as boiler cases or other large appliances,

4All modelsSw15/2 day programming 7 day programmingSw2Optimum start contoller enabled Optimum start contoller disabledSw3Chrono-proportional control

5TP7000 Wiring (not RF models) 7-day - each day can be programmed with different times and temperatures.5/2 day - one set of times & temperatures

6Commissioning (RF versions only)To tune the RX receiver to the frequency of the thermostat signal, follow steps 1-5 belowLEARN1. TP7000-RF Press th

7GB - User InstructionsUser InstructionsGBYour programmable room thermostatThe TP7000 allows you to programme up to 6 different time and temperature s

8Display preferencesTemperature display (°C or °F) Press and hold DAY & COPY (for 2-3 seconds) until display changes.Clock display (12 or 24 hr) P

9GB - User InstructionsThe unit is now in RUN mode (colon fl ashes in display) and the heating will operate according to the preset programmes.a) Pre